Nissan Rogue manuals

Nissan Rogue Service Manual: Power switch illumination circuit

Description

Provides the power supply and the ground to control the power switch illumination.

Component Function Check

1.CHECK POWER SWITCH ILLUMINATION OPERATION

CONSULT ACTIVE TEST

  1.  Turn the power switch ON.
  2.  Select “ENGINE SW ILLUMI” of “BCM” active test item.
  3.  With operating the test items, check that the power switch illumination turns ON/OFF.

On : Power switch illumination ON
Off : Power switch illumination OFF

Does the power switch illumination turn ON/OFF? YES >> Power switch illumination circuit is normal.

NO >> Refer to INL-52, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK POWER SWITCH ILLUMINATION POWER SUPPLY OUTPUT

  1.  Turn power switch OFF.
  2.  Disconnect power switch connector.
  3.  Check voltage between power switch harness connector and ground.

Check power switch illumination power supply output

Is the inspection result normal? YES >> GO TO 4.

NO >> GO TO 2.

2.CHECK POWER SWITCH ILLUMINATION POWER SUPPLY OPEN CIRCUIT

  1.  Turn the power switch OFF.
  2.  Disconnect BCM connector.
  3.  Check continuity between BCM harness connector and the power switch harness connector.

Check power switch illumination power supply open circuit

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace harnesses.

3.CHECK POWER SWITCH ILLUMINATION POWER SUPPLY SHORT CIRCUIT

Check continuity between BCM harness connector and ground.

Check power switch illumination power supply short circuit

Is the inspection result normal? YES >> Replace BCM. Refer to BCS-75, "Removal and Installation" (with intelligent Key system) or BCS- 135, "Removal and Installation" (without Intelligent Key system).

NO >> Repair or replace harnesses.

4.CHECK POWER SWITCH ILLUMINATION GROUND CIRCUIT

  1.  Turn the power switch OFF.
  2.  Check continuity between power switch harness connector and ground.

Check power switch illumination ground circuit

Is the inspection result normal? YES >> Replace power switch. Refer to SEC-112, "Removal and Installation".

NO >> Repair or replace harnesses.

Luggage room lamp circuit
Description Controls the luggage room lamp (ground side) to turn the luggage room lamp ON and OFF. Diagnosis Procedure CAUTION: Before performing the diagnosis, check that the following is norma ...

Symptom diagnosis
INTERIOR LIGHTING SYSTEM SYMPTOMS Symptom Table CAUTION: Perform the self-diagnosis with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected. S ...

Other materials:

Precautions on child restraints
WARNING  Failure to follow the warnings and instructions for proper use and installation of child restraints could result in serious injury or death of a child or other passengers in a sudden stop or collision:  The child restraint must be ...

Rear-facing child restraint installation using LATCH
For additional information, refer to all Warnings and Cautions in the “Child Safety” and “Child Restraint” sections before installing a child restraint. NISSAN does not recommend the use of the lower anchors if the combined weight of the child and the child restraint exceeds 65 lbs (2 ...

Changing a flat tire
If you have a flat tire, follow the instructions below: Stopping the vehicle  Safely move the vehicle off the road and away from traffic.  Turn on the hazard warning flashers.  Park on a level surface and apply the parking brake. Move the shift lever to P (Park).   ...

© 2014-2019 Copyright www.nirogue.com